Vermont American® 13-inch-Long Masonry Drill Bits
Published June 25, 2024 · Recall initiated: June 9, 2006
What's the hazard
The drill bit packages are not properly labeled with precautionary information on proper use and operation. These and other manufacturers' 13-inch bits can bend when run at a high speed without being in contact with a work surface, resulting in loss of control of the drill and possible lacerations. The safety label should read: "! WARNING Read, understand and comply with tool manual before use. Wear eye protection. Max operating speed 600 RPM. At higher speeds the bit is likely to bend if allowed to rotate freely without contacting the work. Start drilling at low RPM and with bit tip in contact with work. To avoid bit bowing - Apply pressure only in direct line with bit and do not apply excessive pressure. Bits can bind, causing breakage or loss of control. Do not use in hammer drills or in drill press."
What to do
Consumers should make sure that 13-inch masonry drill bits are in contact with a work surface at all times while operating the drill. Consumers with these drill bits that are missing the safety instructions should contact Vermont American Customer Service to obtain safety warning information.
Recall details
- Brand
- Robert Bosch Tool Corp., Mt. Prospect, Ill.
- Manufacturer
- Robert Bosch Tool Corp., Mt. Prospect, Ill.
- Distributor
- Hardware stores and home centers nationwide from January 2001 through April 2004 for between $7 and $10.
- Country
- US